Monthly Archives: October 2010

Absorption Inlet Chillers

Another great article from Power Engineering:
Innovation in Turbine Inlet Conditioning” from TIC and GE.
(October 2010, starting on page 51)

The article outlines an option to use absorption chillers instead of mechanical chillers for gas turbine inlet cooling. Using the GT exhaust gas energy as input to run the chillers – there is no (or very minimal) aux load requirement to run the chillers.

Sounds like a great idea to me!!

VN:F [1.9.22_1171]
Rating: 0.0/5 (0 votes cast)
Share

Calibration Gases

There’s a great article in this month’s Power Engineering magazine:
Proper Calibration of Gas Analyzers” by Terrence Kizer.
(October 2010, starts on page 22)

It points out some of the options for CEMS calibration gas cylinders and how the analyzers use them to monitor for analyzer drift.

You should also check on your natural gas chromatograph calibration gas cylinders (if you have an onsite chromatograph) – the closer the calibration gas is to your actual pipeline gas, the more accurate the resulting analysis will be. If you’re still using the same calibration gas determined during site development, you might want to take a second look. Pipeline gas can shift from season to season, and if your calibration gas is significantly different than actual, the accuracy of the reported heating values will be affected.

If your chromatograph is also used for billing purposes – you’ll want to make double sure the calibration gases are correct. Even a 0.2% increase in a plant fuel bill can be a very large number!

VN:F [1.9.22_1171]
Rating: 0.0/5 (0 votes cast)
Share